Create this project yourself with sheet material cut to size by TOSIZE.es!

Joyce

Above average

2 minutes

Description

On the mdf panee l I made a work of art of a sea of cast resin and sand, among other things. The work is finished with an aluminum edge.

A work of art with a base of MDF

I first gave the panel two good coats of black gesso. Then I attached the aluminum edge and covered it with masking tape. For the sand I put a thin layer of casting resin on part of the panel. Here I pressed a thick layer of sand. After 24 hours I removed the loose sand. After this I applied the first layer of water with clear casting resin. I put the shells there. On the edge of the water I applied white casting resin (white mixed with pigment paste) and spread it widely by blowing with a straw. Let this dry again first. The second layer of water has acquired a somewhat transparent turquoise color by means of acrylic ink. The casting resin should be a bit thick so that you get height. Here too I blown the white border. Make sure this is dry again before continuing. The last wave consists of two opaque colors of turquoise by means of acrylic ink for a gradient and again a white border. I also blown out some white here on the water. If necessary, remove the masking tape in parts on pieces where you are finished.